|
|
Things you may need
|
 |
Instructions:
First install the pond container liner. If you're using a wooden half-barrel,
line it with a sheet of pond liner.
Partially fill the pond container with water in order to hold the liner in place while you trim it. Fasten the upper edge of the liner to the top of the
pond container, just inside the rim.
Place the plastic liner between the pond container surface and the narrow wooden or metal strips.
Fasten together with galvanized screws. If necessary, empty the container and position it where you want your water garden to be located.
Place the container on a sturdy, level surface where it will receive a
few hours of sunshine each day. The tub may weigh up to 10 lbs per gallon of water
once filled. You can partially bury the container in the ground.
Doing this, helps in hot climates where the summer sun will overheat small above-ground
water gardens.
Fill your container with water until it is about 2/3 full. Wait at least 24 hours before adding any plants. If you plan to add fish to the pool,
you should use a water conditioner, such as Amquel, to neutralize any chemicals before adding your fish.
You should also install a water pump to circulate the water. For the soothing sound of splashing water, use a
small fountain attached to a re-circulating water pump.
Read ALL instructions regarding the safety of the pump! Note:
Floating plants, such as water lilies, do better without water splashing on their leaves.
Add any plants that you want to your new water pond! Place newspaper over the
holes in the pots to prevent soil from getting out.
Quick Tip
Plants should cover about 1/2 to 3/4 of the water's surface.
